9% OFF
electronics modules
(0)
2.13" E-Ink Display HAT for Raspberry Pi & Arduino - Black & White SPI
SKU: BBZ-ELDI-059• Available on Backorder
₹1425₹1570-9% OFF
Key Highlights
- ✓No backlight required; content remains visible even when powered off Ultra‑low power consumption (power needed only during refresh) 2.13‑inch E‑Ink display with clear, paper‑like appearance Supports partial and full refresh modes SPI communication interface Standard 40‑pin Raspberry Pi GPIO header Compatible with Raspberry Pi series and Jetson Nano Onboard voltage translator supporting both 3.3V and 5V systems Wide viewing angle (>170°) with excellent sunlight readability Preserved solder pads for use with Arduino, STM32, and Nucleo boards Includes development resources and example codes
1
Delivery1 – 11 Business Days
Check Delivery
Enter your 6-digit PIN to check COD & estimated delivery.
Safe Checkout
UPI
Earn 112 Bits
≈ ₹112 cashback on this order
Free Shipping
Ships in 2–3 business days
Secure Checkout 5-Day Returns Store Pickup · Pune Same-Day · Pune
Display Size
2.13 inch Resolution: 250 × 122 pixels Display Colors: Black and White Grey Level: 2 Interface: SPI Operating Voltage: 3.3V / 5V Partial Refresh Time: 0.3 seconds Full Refresh Time: 2 seconds Dot Pitch: 0.194 × 0.194 mm Viewing Angle: >170° Refresh Power Consumption: 26.4 mW (typical) Standby Power Consumption: <0.017 mW Outline Dimensions: 65 × 30.2 mm Active Display Area: 23.71 × 48.55 mm