TL084 Quad JFET-Input Op-Amp IC DIP for Arduino, ESP32 & Robotics Projects
Key Highlights
- ✓Low power consumption (~ 1.4 mA per channel, typical) Wide common-mode and differential voltage ranges Low input bias current (≈ tens of pA) Low input offset current (few pA) Output short-circuit protection Low total harmonic distortion (≈ 0.003%, typical) JFET input stage → high input impedance Latch-up free operation High slew rate (≈ 13 V/µs typical in many versions) Good common-mode input range, including up to VCC⁺ in some variants
Enter your 6-digit PIN to check COD & estimated delivery.
Earn 0 Bits
≈ ₹0 cashback on this order
₹50 Flat Delivery
Ships in 2–3 business days
Below is a table summarizing typical and absolute values for the TL084 family (varies with variant and conditions)
Parameter Typical / Max Value Notes / Conditions Number of channels 4 Quad op amp micros.com.pl +2 Analog Devices +2 Supply voltage (max) ±18 V Absolute maximum rating micros.com.pl +1 Supply voltage for normal operation ±5 V to ±15 V (i.e. 10 V to 30 V total) Many versions operate between +5 to +15 V single supply or ± voltages Analog Devices +1 Input offset voltage (Vos, max) ~ 6 mV (in your provided spec) Some datasheets list ~ 5.5 mV or higher, depending on variant Analog Devices +2 micros.com.pl +2 Quiescent current per channel (Iq) ~1.4 mA typical Matches your spec; datasheets list ~1.4 mA per amplifier micros.com.pl +1 Input noise (Vn @ 1 kHz) ~18 nV/√Hz Typical for TL08x family Texas Instruments +2 micros.com.pl +2 Input bias current (max) ~200 pA For some variants; typical cases are lower electronperdido.com +2 micros.com.pl +2 Common-Mode Rejection Ratio (CMRR, typical) ~86 dB As per your spec and datasheet ranges ampslab.com +2 Analog Devices +2 Output current (typical) ~10 mA Matches your spec for typical load drive Analog Devices +1 Operating Temperature Range Varies by variant (e.g. 0–70 °C, –40–85 °C, –55–125 °C) Depends on the version (C, I, M, etc.) micros.com.pl +2 electronperdido.com +2 Offset drift (typical) ~18 µV/°C As per your provided spec; datasheet values vary per variant